OBDSTAR X300M Odometer Adjustment on Peugeot/ Citroen Notice

auto key programmer

OBDSTAR X300M is specially developed for odometer adjustment, which makes it devoted and professional. There’re some things you need to keep in mind while working on Peugeot/Citroen cars with X300 odometer correction tool.

Notice:
1. During the mileage adjustment process, ensure the power is sufficient and the voltage is stable.

2. Before performing the adjustment function, you must read and save the instrument and BSI data (EEPROM and FLASH) first.

3. For the mileage adjustment, it needs to adjust the instrument and BSI module at the same time. If one of them is adjusted first, it will be synchronized by the data of another module and restored to the original mileage. The solution is as follows:

Option 1): First remove the adjustment (do not pull the plug), and then adjust the instrument mileage through OBD. After the adjustment is successful, immediately unplug the instrument (as fast as possible), and then adjust the BSI mileage through OBD. The value is consistent with the instrument. After that, enter the reading mileage, confirm the mileage to be adjusted, and then install the instrument;
obdstar-x300m-odometer-adjustment-notice-01

Option 2): First adjust the instrument mileage through OBD. After the adjustment is successful, immediately unplug the instrument power supply fuse (as fast as possible, it is recommended to unplug the fuse before adjusting the instrument to check whether the instrument is powered off), and then adjust the BSI mileage through OBD. The value is consistent with the instrument. After that, enter the reading mileage, confirm the mileage to be adjusted, and then install the instrument fuse.

The instrument fuse is on the BSI, and the BSI position is generally below the steering wheel, as shown below.
obdstar-x300m-odometer-adjustment-notice-02

Note: The position of the fuses may vary depending on years and models. According to the BSI module brand type, Valeo is generally F21, Continent is generally F19, and JHNSON CONTRLS is generally F12…;
obdstar-x300m-odometer-adjustment-notice-03

4. BSI menu is based on types, such as “CONTINENTAL BSI-Q0X”, where CONTINENTAL is the BSI brand name. Q0X is the BSI type, X stands for any number 0-9, and the device can automatically recognize. If not, the types are not supported. Types can be seen on the BSI module label, as shown below.
obdstar-x300m-odometer-adjustment-notice-04

obdstar-x300m-odometer-adjustment-notice-05

OBDSTAR X300M PSA Car List:
Citroen
BSI:
Auto Select & Manual Select
CONTINENTAL BSI-Q0X JC
BSI04EV-K0X
JC BSI2004-H0X
SIEMENS BSI-E0X/BSI-F0X VALEO BSI-N0X
VALEO BSI2004-P0X

DASH:
C3, 2009
C4, 2010- C4L
C4, Cactus Mono 2014-
C4, Picasso TFT 2014-
C4, Picasso Mono, 2014-
C5, 2008
DS3, Mileage adjustment, Read EEPROM (Backup), Write EEPROM (Restore)
DS4, DS5, Mileage adjustment, Read EEPROM (Backup), Write EEPROM (Restore)
Jumper 2015

PEUGEOT:
BOXER 2015

The full supported car list could be found via:
https://www.chinacardiags.com/upload/pro/19091715687115071259.pdf