Steps to obtain Audi A4 radio codes using ODIS-S software:
Select “Start Diagnosis”
Select “Manual” for the vehicle identification
Select “Yes” to perform diagnosis without guided fault finding
Model: Previous Models for Immobilizer-Online
This selection will automatically set all of the other selections as “All”.
Next, deselect “Work with Guided Fault Finding” box and press the “Apply” button.
ODIS will now run a quick check and after when it is done, select the “Special Functions” tab
Select the “Checking Radio Code” test, then “Perform Test”
Select “OK”. A vehicle change was detected durng diagnostic session in progress
The test will now start. Press the “Complete/Continue”
Enter the VIN in the “Red” box and select “Accept”.
Enter the AUZ number in the “Red” box and select “Accept”.
Enter name in the “Red” box and select “Accept”.
Enter number in the “Red” box and select “Accept”.
Enter the country in the “Red” box and select “Accept”.
After completing the vehicle and client information, this screen appears.
Press the “Complete/Continue” button.
Enter your GEKO ID information in the box and select the “Apply” button.
After pressing the button the test will start. The radio code retrieving test will go through a series of checks and steps in order to obtain the code. Some of the screens will show the following…….
- The connection wasestablished
- Next, the data will be
- The data was
The tester waits for data to be received.
- The tester evaluates the received
After the connection is established and the tester retrieved the radio code, this next screen will show up with your number. Press the Complete/Continue button to exit test.
Job’s done!
ODIS works well for radio codes!